🏁ATTENTION!! CANADA POST IS ON STRIKE. ALL SHIPMENTS WILL BE DELAYED UNTIL FURTHER NOTICE. THANK YOU!!🏁



Tire Stack Style Street Light for Carrera D132/124/Evo Tracks

Slot Car Mancave

Prix régulier $3.89

Frais de port calculés à l'étape de paiement.

The Slot Car Mancave - Tire Stack - Light Post Clip with Ver.2, 3v LED light pole. (Unpainted)

Designed for 1:32 scale slot car tracks.

Sold Individually

Each unit stands approximately 7.35 inches tall from the base of the clip to the top of the light fixture. We aimed for a selective compression ratio of 6:1 which is over 7 inches tall. This ratio is commonly used for 1:32 scale slot car tracks. Since most buildings and scenery is also 1:32 centric and so is our product.

We designed and manufacture our product so that it clips directly in to Carrera Evolution, and Digital 132/124 track. Each unit includes (1)one 3 volt, 20mah, bright white SMD LED light pole, pre-threaded into (1) one Slot Car Mancave - Tire Stack - Light Post Clip. 

The hole down the center passes through to the bottom where we have designed a wire channel and guide to pass the wires underneath the track through the clip, which removes the potential of pinching the wires while fastening down the clip to your surface.

You will need some intermediate soldering skills for wiring up the lights as they will arrive pre-stripped and unterminated.

The lights also DO NOT come with a resistor, we were not supplied with any and haven't needed them by using the recommended light control product.

The lights DO NOT wire directly to your track power. We do not recommend powering these LED's with track power, and neither does Carrera, it will damage the CU and void your warranty.

We recommend powering our lights in parallel with a 3V1A power supply and wire and shrink wrap are available in the Track Lighting Products Section. -This is the same power supply used for our other slot car street light products which means that the curb lights and street lights can both be wired to the same parallel rail together.

This product is 3D printed in white to simulate a wrapped stack of tires resting around a light pole. They can be painted to add red stripes; as seen in the images, or wrapped with a sticker if you prefer. The tire stack is modeled after a 1:32 scale tire for reference(pictured), so that it is to scale.

Tire and Slot Car are not included...🙂

Enjoy lighting up your track today!

Designed and manufactured in-house by Slot Car Mancave and not available from any resellers.