The Slot Car Mancave Light Post Clip & Track Fastener with 3v LED light pole installed.
Designed for 1:32 scale slot car tracks.
Each unit stands approximately 7.35 inches tall from the base of the clip to the top of the light fixture. We aimed for a selective compression ratio of 6:1 which is over 7 inches tall. This ratio is commonly used for 1:32 scale slot car tracks. Since most buildings and scenery is also 1:32 centric, so is our product.
Our clips can be purchased separately for those wanting to buy 1:50 scale LED light poles of their own to suit 1:24 scale tracks. Our clips can be drilled out to 3mm to accommodate the larger 1:50 light poles if you prefer them. -Please see our other listing for packs of 10.
We designed and manufacture our product so that it clips directly in to Carrera Evolution, and Digital 132/124 track. Each unit includes (1)one 3 volt, 20mah, bright white SMD LED light pole, pre-threaded into (1) one Slot Car Mancave Light Post Clip & Track Fastener.
The hole down the center passes through to the bottom where we have designed a wire channel and guide to pass the wires underneath the track through the clip, which removes the potential of pinching the wires while fastening down the clip to your surface.
You will need some intermediate soldering skills for wiring up the lights as they will arrive pre-stripped and unterminated.
The lights also DO NOT come with a resistor, we were not supplied with any and haven't needed them by using the recommended light control product.
The lights DO NOT wire directly to your track power. We do not recommend powering these LED's with track power, and neither does Carrera, it will damage the CU and void your warranty.